D according to sequence-specific assignments. Residues N3, T4, A5, and A8 are only visible at lower contours than shown. The group of crosspeaks connected by horizontal lines between 
109 and 111 ppm (15N) are unassigned sidechain amide groups from the 6 Asn and 1 Gln in amylin. (B)Spectrum of a 15N-amylin after 4 days (99h) of D2O exchange in the fibril state, recorded in 95 d6-DMSO/5 d2-DCA. Strongly protected amide protons are labeled in bold type. doi:10.1371/journal.pone.0056467.gFigure 2. Representative solvent exchange kinetics for amide protons in amylin fibrils. Error bars were estimated from the average root-mean-square baseline noise of the 1H-15N HSQC spectra. The curves are fits of amide proton intensity decay data to an exponential model: y = I0 exp(-t x), obtained using the program KaleidaGraph v 4.1.3 (Synergy Software). The two free variables in the fits were I0, the initial amplitude and t, the time constant for exchange. doi:10.1371/journal.pone.0056467.gN Nfibrils suggest that L27 is not in a b-sheet conformation but otherwise support b-sheet get Dimethylenastron structure for all residues between G24T36 (c.f. Supplementary Table 1 of [10]). Except for residue L27, the ssNMR chemical shift data could be consistent with the Nterminus of strand b2 starting at G24 and the C-terminus of strand b1 ending at residue S20. While strong protection is not seen for any of the residues in the S19-G24 segment, this need not preclude b-sheet structure as residues A8-N14 in strand b1 and G33-N35 in strand b2 are weakly protected (Fig. 3). In terms of the structural models based on the ssNMR data, residues I26-L27 have dihedral angles that fall well within the b-sheet region of Ramachandran plots in 10 out of 10 structures. This is also evident for the PyMol [39] generated ribbon diagram of the ssNMR amylin fibril model in Fig. 4B, where residues I26-L27 are indicated in light blue and are identified by the program as belonging to a b-sheet structure based on their dihedral angles. Dihedral angles that fall outside of the b-sheet region are not seen until residues N21-G24 in the ssNMR models. The distinguishing feature of the I26-L27 segment in the 23727046 ssNMR model is that it does not form b-sheet hydrogen bonds unlike the rest of the residues S28-Y37 in strand b2. In NMR structures, residues are typically restrained to form hydrogen bonds based on HX protection data. While it is possible that the HX protection observed herein for I26-L27 is due to burial of these residues in the core of the structure rather than bsheet hydrogen bonding, that ssNMR chemical shifts are also consistent with b-sheet structure suggests that this segment is part of strand b2. Inclusion of the I26-L27 segment as the beginning ofHydrogen Exchange in Amylin FibrilsFigure 3. Time constants for hydrogen exchange as a function of residue position in the sequence. The top of the figure 15755315 indicates the position of the two b-strands reported for the ssNMR [10] and EPR models of the amylin fibril structure, as well as the revised secondary structure limits based on the qHX data in this work. Uncertainties in exchange time constants were estimated from standard MedChemExpress [DTrp6]-LH-RH errors of the fits of the qHX data to exponential decays (Fig. 2). The symbols `*’ indicate amide protons that exchange with rates too fast to measure, `U’ indicates that the amide proton of T6 is unassigned. doi:10.1371/journal.pone.0056467.gstrand b2 would lead to better packing interactions against the Cterminal end of strand b1 an.D according to sequence-specific assignments. Residues N3, T4, A5, and A8 are only visible at lower contours than shown. The group of crosspeaks connected by horizontal lines between 109 and 111 ppm (15N) are unassigned sidechain amide groups from the 6 Asn and 1 Gln in amylin. (B)Spectrum of a 15N-amylin after 4 days (99h) of 
D2O exchange in the fibril state, recorded in 95 d6-DMSO/5 d2-DCA. Strongly protected amide protons are labeled in bold type. doi:10.1371/journal.pone.0056467.gFigure 2. Representative solvent exchange kinetics for amide protons in amylin fibrils. Error bars were estimated from the average root-mean-square baseline noise of the 1H-15N HSQC spectra. The curves are fits of amide proton intensity decay data to an exponential model: y = I0 exp(-t x), obtained using the program KaleidaGraph v 4.1.3 (Synergy Software). The two free variables in the fits were I0, the initial amplitude and t, the time constant for exchange. doi:10.1371/journal.pone.0056467.gN Nfibrils suggest that L27 is not in a b-sheet conformation but otherwise support b-sheet structure for all residues between G24T36 (c.f. Supplementary Table 1 of [10]). Except for residue L27, the ssNMR chemical shift data could be consistent with the Nterminus of strand b2 starting at G24 and the C-terminus of strand b1 ending at residue S20. While strong protection is not seen for any of the residues in the S19-G24 segment, this need not preclude b-sheet structure as residues A8-N14 in strand b1 and G33-N35 in strand b2 are weakly protected (Fig. 3). In terms of the structural models based on the ssNMR data, residues I26-L27 have dihedral angles that fall well within the b-sheet region of Ramachandran plots in 10 out of 10 structures. This is also evident for the PyMol [39] generated ribbon diagram of the ssNMR amylin fibril model in Fig. 4B, where residues I26-L27 are indicated in light blue and are identified by the program as belonging to a b-sheet structure based on their dihedral angles. Dihedral angles that fall outside of the b-sheet region are not seen until residues N21-G24 in the ssNMR models. The distinguishing feature of the I26-L27 segment in the 23727046 ssNMR model is that it does not form b-sheet hydrogen bonds unlike the rest of the residues S28-Y37 in strand b2. In NMR structures, residues are typically restrained to form hydrogen bonds based on HX protection data. While it is possible that the HX protection observed herein for I26-L27 is due to burial of these residues in the core of the structure rather than bsheet hydrogen bonding, that ssNMR chemical shifts are also consistent with b-sheet structure suggests that this segment is part of strand b2. Inclusion of the I26-L27 segment as the beginning ofHydrogen Exchange in Amylin FibrilsFigure 3. Time constants for hydrogen exchange as a function of residue position in the sequence. The top of the figure 15755315 indicates the position of the two b-strands reported for the ssNMR [10] and EPR models of the amylin fibril structure, as well as the revised secondary structure limits based on the qHX data in this work. Uncertainties in exchange time constants were estimated from standard errors of the fits of the qHX data to exponential decays (Fig. 2). The symbols `*’ indicate amide protons that exchange with rates too fast to measure, `U’ indicates that the amide proton of T6 is unassigned. doi:10.1371/journal.pone.0056467.gstrand b2 would lead to better packing interactions against the Cterminal end of strand b1 an.
